Masonry Water Repellents

Resealing Your Garage Floor

If your garage floor has ever had an existing sealer applied, then this article will help you successfully re-seal your garage floor.

Step 1: Clean the Surface

When the surface of the garage begins to exhibit a dull or uneven appearance, apply a single maintenance coat of sealer. When applying a maintenance coat, clean the surface using a mild detergent and water. If there are oil stains embedded in the concrete, remove them with MasonrySaver Cleaner & Degreaser.

Step 2: Allow the surface to dry

Applying a sealer on a damp surface can result in a “blushing” effect, which is a cloudy appearance as moisture becomes trapped inside of it.

Step 3: Touch-up Worn Areas

If areas of the previous sealer have broken down completely, touch those areas with a coat of sealer prior to sealing the entire floor. This will help to create an even sheen across the entire surface of the floor and will provide adequate protection against wear in those areas that have broken down.

Step 4: Apply a Single Coat of Concrete Sealer

Seal the garage with one coat of MasonrySaver Garage Floor Sealer according to label directions. The sealer can be applied using a brush and roller or by spraying using a garden variety pump-up type sprayer or airless sprayer.

Avoid puddling or ponding of the product. Allow a minimum of one to two hours dry time prior to applying second coat of sealer. The second coat requires four hours dry time before the surface is subjected to foot traffic. Full cure of the sealer is achieved within five days. To avoid ‘hot tire’ release of the sealer, avoid parking vehicles on the floor until full cure is achieved. Use caution; sealed surfaces will become slippery when wet.

Step 5: Maintain the sealer

A single maintenance coat of sealer is needed when the surface of the garage begins to exhibit a dull or uneven appearance. When time, simply follow the above steps to keep your garage floor protected and looking new.

Leave a Reply

Your email address will not be published.