Read the Label - Brick & Mortar Cleaner
ChimneySaver Brick & Mortar Cleaner is a proprietary formulation of special acids and cleaners that effectively remove rust, mildew, algae, smoke, and creosote stains. It is a safer alternative to muriatic acid.
DIRECTIONS FOR USE
SURFACE PREPARATION:
IMPORTANT NOTES: ChimneySaver Brick & Mortar Cleaner will dissolve limestone. Always test in an inconspicuous area to ensure desired results. Protect foliage and all applicable surrounding surfaces including wood, glass, aluminum, asphalt roofing, vinyl siding, and painted surfaces. Beware of wind drift.
APPLICATION
DILUTION: Dilute ChimneySaver Brick & Mortar Cleaner 4:1 with water. For difficult to remove stains, this product can be used full strength. CAUTION: When diluting product with water, slowly add product to water while stirring. Never add water to the product.
1) Brush surfaces to be cleaned with a stiff brush to remove loose particles.
2) Wet all surfaces to be cleaned with liberal amounts of water.
3) Flood the surface with ChimneySaver Brick & Mortar Cleaner, taking care that the product does not run down onto non-targeted areas.
4) Scrub the area thoroughly with a stiff non-metal brush, allowing the cleaning solution to remain on the area for three to five minutes.
5) Thoroughly rinse the treated area using a garden hose with an adjustable nozzle or a pressure washer set at 400-600 psi. To avoid streaking, rinse from the bottom up.
For severely stained areas, it may be necessary to repeat the application of ChimneySaver Brick & Mortar Cleaner.
PRECAUTIONS
Keep out of reach of children. Keep container closed. Do not take internally. The use of chemical splash gloves and a NIOSH-approved respirator is highly recommended when using this product. For additional information on this product, consult the product data sheet and SDS for this product at www.chimneysaver.com.
FIRST AID: If swallowed, do NOT induce vomiting. Drink 1-2 glasses of water or milk and call for medical help immediately. In case of eye contact, flush with water immediately. Remove contact lenses if present and easy to do so and continue to flush with water for 15 minutes. For skin contact, wash with soap and plenty of water. If redness or swelling occurs, seek medical attention.
LIMITED WARRANTY
Our recommendations for use of this product are based upon tests believed to be reliable. Since field conditions vary widely, the user must determine the suitability of the product for the particular use and specific method(s) of application. Due to the fact that SaverSystems has no control over surface preparation and application methods, no guarantee as to results is offered, expressed, or implied. SaverSystems warrants this product to be free from defects. SaverSystems’ liability shall be limited in all events to supplying enough product to re-treat the specific areas to which defective product has been applied. This warranty does not include the cost of labor for application. SaverSystems shall not have any other liability including direct, incidental, or consequential damages. Some states do not allow the exclusion of incidental or consequential damages so this limitation or exclusion may not apply to you. This warranty gives you specific legal rights. You may also have other rights which vary from state to state.
VOC Content: 47 g/L